Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System) › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255506 PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)  C168D  Vehicle Information Unmatched  


DESCRIPTION

This DTC is stored if the multi-media module receiver assembly judges as a result of its self check that the vehicle information received via CAN communication and the vehicle information stored in the multi-media module receiver assembly do not match.

DTC Code DTC Detection Condition Trouble Area
C168D Vehicle Information Unmatched
·

Back camera position setting

·

Steering angle setting

·

Side camera position setting

·

Multi-media module receiver assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the multi-media module receiver assembly after the battery terminal disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)>CALIBRATION).



PROCEDURE

1.PERFORM SETTINGS (BACK CAMERA POSITION SETTING, STEERING ANGLE SETTING, SIDE CAMERA POSITION SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the multi-media module receiver assembly.






NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System)>DTC CHECK / CLEAR).

OK:

DTC C168D is not output.


HINT:
·

If DTC C168D is output, perform the procedure to allow the multi-media module receiver assembly to store the vehicle information again.

·

If DTC C168D is still output after performing the procedure to make the multi-media module receiver assembly store the vehicle information 3 times, replace the multi-media module receiver assembly.





OK

END (SETTINGS ARE DEFECTIVE)

NG

REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY