1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
55510F
3.REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY
55670
4.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
55680A
5.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
86120
6.REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET
Remove the 2 screws and 2 bolts.
Pull the radio receiver to detach the 10 claws on the backside of the radio receiver.
Disconnect the connectors and remove the radio receiver.
86211
7.REMOVE NO. 1 RADIO BRACKET
Remove the 3 bolts and bracket.
86212
8.REMOVE NO. 2 RADIO BRACKET
Remove the 3 bolts and bracket.
83910
9.REMOVE CLOCK ASSEMBLY
84330
10.REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY