Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87940
1.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
87961
2.REMOVE OUTER MIRROR LH
87945B
3.REMOVE OUTER MIRROR COVER LH
81740
4.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
86790C
5.REMOVE SIDE TELEVISION CAMERA ASSEMBLY
Remove the gasket
Remove the tape.
Detach the 9 guides and remove the gasket.
Slightly lower the gasket so that the television camera assembly can be removed.
Remove the lower mirror cover
Using a screwdriver with its tip wrapped in protective tape, disconnect the 4 claws and remove the lower mirror cover.
| *1 | Protective Tape |
Remove the base
Remove the wire harness.
Using "TORX" socket wrench T25, remove the 3 screws.
Make sure to replace the "TORX" screws with new ones.
Disconnect the guide and remove the base.
Detach the connector from the wire clip.
Using a screwdriver, disconnect the connector.
Tape the moulding remover before use.
| *1 | Protective Tape |
Remove the body
Remove the 5 screws and body.
Remove the body
Disconnect the 2 guides and remove the body.
Be careful not to break the guide shown in the part of the illustration labeled A.
Remove the 3 screws and side television camera.