Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › SIDE MONITOR SYSTEM › 2014.08–2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255511 SIDE MONITOR SYSTEM C

PARK ASSIST / MONITORING  SIDE MONITOR SYSTEM  C1693  Side Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the side camera initial setting has not been memorized (side television camera optical axis adjustment is incompleted).

DTC Code DTC Detection Condition Trouble Area
C1693 Side camera initial setting has not been memorized
·

Side television camera optical adjustment

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the parking assist ECU after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>SIDE MONITOR SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the side monitor system may be needed (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>SIDE MONITOR SYSTEM>CALIBRATION).



PROCEDURE

1.ADJUST SETTINGS
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

i.

Refer to side television camera optical axis adjustment (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>SIDE MONITOR SYSTEM>CALIBRATION).




NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>SIDE MONITOR SYSTEM>DTC CHECK / CLEAR).

OK:

DTC C1693 is not output.


HINT:
·

If DTC C1693 is output, perform the side television camera assembly optical axis adjustment again.

·

If DTC C1693 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the parking assist ECU.





OK

END (SETTINGS ARE DEFECTIVE)

NG