Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255514 BLIND SPOT MONITOR SENSOR A

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Avoid any impact to the blind spot monitor sensor.

·

Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.



HINT:
·

The blind spot monitor beam axis inspection is performed to confirm whether the sensor is transmitting radio waves.

·

The blind spot monitor beam axis confirmation is performed to confirm whether the sensor's beam axis is correct, and perform adjustment of the beam axis by using reflector.

·

The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is placed vertically to the ground (+/-5°) by using a jig, and that the sensor is 16 to 24° from the line parallel to the vehicle center line.



PROCEDURE

Hide 88171 1.INSTALL BLIND SPOT MONITOR BRACKET LH

a.

Install the blind spot monitor bracket LH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 88161 2.INSTALL BLIND SPOT MONITOR BRACKET RH

HINT:

Use the same procedure described for the LH side.


Hide 88172 3.INSTALL BLIND SPOT MONITOR SENSOR LH

a.

Install the blind spot monitor sensor LH with the 3 nuts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the connector.


Hide 88162 4.INSTALL BLIND SPOT MONITOR SENSOR RH

HINT:

Use the same procedure described for the LH side.


Hide 5. PERFORM BLIND SPOT MONITOR INSTALLATION CONDITION INSPECTION

Hide 7. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION

Hide 8. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION