Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
52159
1.REMOVE REAR BUMPER COVER
for Standard:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(for Standard)>REMOVAL)
w/ Towing Hitch:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER (w/ Towing Hitch)>REMOVAL)
w/ Pintle Hook:
(See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR BUMPER(w/ Pintle Hook)>REMOVAL)
88172
2.REMOVE BLIND SPOT MONITOR SENSOR LH
Disconnect the connector.
| *a | Nut |
| *b | Connector |
Remove the 3 nuts and blind spot monitor sensor LH.
88162
3.REMOVE BLIND SPOT MONITOR SENSOR RH
Use the same procedure described for the LH side.
88171
4.REMOVE BLIND SPOT MONITOR BRACKET LH
Remove the 3 nuts and blind spot monitor bracket LH.
88161
5.REMOVE BLIND SPOT MONITOR BRACKET RH
Use the same procedure described for the LH side.