51937C
1.REMOVE SPARE WHEEL CARRIER HINGE BRACKET (w/ Tire Carrier)
51902A
2.REMOVE SPARE WHEEL COVER SUB-ASSEMBLY (w/ Tire Carrier)
51903B
3.REMOVE SPARE WHEEL CARRIER SUB-ASSEMBLY (w/ Tire Carrier)
76626E
4.REMOVE REAR QUARTER PANEL MUDGUARD LH
76625G
5.REMOVE REAR QUARTER PANEL MUDGUARD RH
52162B
6.REMOVE REAR BUMPER NO. 1 PLATE (for Step)
Put protective tape around the rear bumper No. 1 plate.
Detach the 20 claws and remove the rear bumper No. 1 plate.
| *a | Protective Tape | - | - |
52159
7.REMOVE REAR BUMPER COVER
For the rear bumper cover with tire carrier, use the procedures described below.
Put protective tape around the rear bumper cover.
| *a | Protective Tape |
Open the tail gate and remove the 4 clips.
Close the tail gate.
Remove the 2 bolts, 6 screws and 2 clips.
| *a | Bolt |
Remove the 5 bolts.
Detach the 7 claws.
Use the same procedure for the other side.
Remove the rear bumper cover.
w/ TOYOTA Parking Assist-sensor System or w/ Rear Fog Light:
Disconnect the No. 2 frame wire connector.
58724B
8.REMOVE NO. 2 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Remove the 2 screws, 2 grommets and No. 2 luggage compartment side cover protector.
58723B
9.REMOVE NO. 1 LUGGAGE COMPARTMENT SIDE COVER PROTECTOR
Use the same procedure described for the LH side.
81560
10.REMOVE REAR COMBINATION LIGHT ASSEMBLY LH
81550
11.REMOVE REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52563D
12.REMOVE REAR BUMPER UPPER RETAINER LH
Detach the 2 clips and remove the rear bumper upper retainer LH.
52562E
13.REMOVE REAR BUMPER UPPER RETAINER RH
Use the same procedure described for the LH side.
52156A
14.REMOVE REAR BUMPER SIDE SUPPORT LH
Remove the 3 screws.
Detach the 6 claws and remove the rear bumper side support LH.
52155A
15.REMOVE REAR BUMPER SIDE SUPPORT RH
Use the same procedure described for the LH side.
52172B
16.REMOVE REAR BUMPER NO. 2 REINFORCEMENT
Remove the 2 bolts and rear bumper No. 2 reinforcement.
57615C
17.REMOVE REAR BUMPER ARM BRACKET
Remove the bolt and rear bumper arm bracket.
Use the same procedure for both rear bumper arm brackets.
57616B
18.REMOVE REAR BUMPER ARM BRACKET LH
Disconnect the clamp.
Remove the 2 bolts and rear bumper arm bracket LH.