Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › MULTI-TERRAIN MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255515 MULTI-TERRAIN MONITOR SYSTEM C

PARK ASSIST / MONITORING  MULTI-TERRAIN MONITOR SYSTEM  C1626  Steering Angle Sensor Failure  


DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates an internal malfunction.

DTC Code DTC Detection Condition Trouble Area
C1626 A fail flag is transmitted from the steering angle sensor.
·

Steering sensor

·

Parking assist ECU



CAUTION / NOTICE / HINT

NOTICE:
·

When "!" mark is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>MULTI-TERRAIN MONITOR SYSTEM>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



PROCEDURE

1.REPLACE STEERING SENSOR

NEXT

2.CHECK FOR DTC
2.CHECK FOR DTC

OK

END (STEERING SENSOR IS DEFECTIVE)

NG