DESCRIPTION
Blind spot monitor data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and to perform repair it.
CHECK DLC3
Check the DLC3 (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>GENERAL INFORMATION).
DIAGNOSIS FUNCTION
The blind spot monitor system displays an error message on the multi-information display to inform the driver that the system is unavailable either temporarily or due to a malfunction.
When the system is unavailable temporarily:
Multi-information display displays "BSM not available".
When the system is unavailable due to a malfunction:
Multi-information display displays "Check BSM System".
Indicates on the multi-display assembly that the system cannot be used due to a malfunction or is temporarily unavailable to notify the driver.
ABNORMALITY HISTORY
The abnormality history for a blind spot monitor sensor can be displayed or cleared.
Check abnormality history
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Turn the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History.
Check the results displayed for the abnormality history check.
If "Yes" is displayed, check the suspected area column for each item.
Abnormality history is stored only for the blind spot monitor sensor for which an abnormality has been detected.
If "No" is displayed, refer to Problem Symptoms Table (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>PROBLEM SYMPTOMS TABLE).
Clearing abnormality history
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Turn the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History.
Clear the abnormality history.