Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › from 2015.08
RM2660E _56 Audio / Visual / Telematics _052831 PARK ASSIST / MONITORING _0255516 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A45  Vehicle Speed Sensor  


DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the master cylinder solenoid (skid control ECU) via CAN communication.

DTC No. DTC Detection Condition Trouble Area
C1A45 A fail flag is transmitted from the brake actuator assembly (skid control ECU).
·

Vehicle stability control system

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.


PROCEDURE

1.CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM)
a.

Check for vehicle stability control system DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

OK:

Vehicle stability control system DTCs are not output.




OK

2.CHECK FOR DTC

NG

2.CHECK FOR DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTCs are output. A
DTC C1A45 is output ("Blind Spot Monitor Master"). B
DTC C1A45 is output ("Blind Spot Monitor Slave"). C



A

B

C