| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Gateway ECU Communication Stop Mode | Either condition is met:
·
"CAN Gateway" is not displayed on the "Bus Check" screen. ·
"Gateway ECU Communication Stop Mode" in "DTC Communication Table" applies. |
·
Power source or inside of network gateway ECU ·
Network gateway ECU CAN branch wire or connector ·
Network gateway ECU |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
NEXT
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
For vehicles with an SRS system:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
NEXT
Disconnect the E31 network gateway ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E31-16 (CA1H) - E31-15 (CA1L) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector
(to Network Gateway ECU) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E31-4 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E31-2 (BATT) - Body ground | Always | 11 to 14 V |
| E31-10 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
| E31-9 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector
(to Network Gateway ECU) |
OK
NG