Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU (for RHD) › 2014.08–2015.08
RM2660E _57 Power Source / Network _052837 NETWORKING _0255531 NETWORK GATEWAY ECU(for RHD) A

NETWORKING  NETWORK GATEWAY ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Driver Side Knee Airbag)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913B 3.REMOVE FRONT DOOR SCUFF PLATE RH

a.

w/ Sliding Roof:

Remove the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL).


b.

w/o Sliding Roof:

Remove the front door scuff plate (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL).


Hide 55449C 4.REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

a.

w/o Console Box Lid:

i.

Remove the No. 2 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>REMOVAL).



b.

w/ Cool Box:

i.

Remove the No. 2 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>REMOVAL).



c.

w/o Cool Box:

i.

Remove the No. 2 instrument panel finish panel cushion (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>REMOVAL).



Hide 55402C 5.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

a.

w/o Console Box Lid:

i.

Remove the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Console Box Lid)>REMOVAL).



b.

w/ Cool Box:

i.

Remove the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/ Cool Box)>REMOVAL).



c.

w/o Cool Box:

i.

Remove the lower instrument panel pad sub-assembly RH (See page Vehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX(w/o Cool Box)>REMOVAL).



Hide 55474C 6.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55475A 7.REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

Hide 55606 8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)

Hide 55432D 9.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

Hide 73900 11.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Driver Side Knee Airbag)

Hide 55303B 12.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (w/o Driver Side Knee Airbag)

Hide 89111 13.REMOVE NETWORK GATEWAY ECU

E154162

a.

Disconnect the connector.


b.

Remove the nut and ECU.