Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69278B
4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
74240A
5.REMOVE FRONT DOOR ARMREST BASE PANEL ASSEMBLY LH
74646
6.REMOVE DOOR ASSIST GRIP COVER LH
81230
7.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
67602
8.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
67832
9.REMOVE FRONT DOOR SERVICE HOLE COVER LH
67924
10.REMOVE FRONT NO. 2 DOOR STIFFENER CUSHION
67404F
11.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH
69218B
12.REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH
69320
13.REMOVE FRONT DOOR LOCK ASSEMBLY LH
Using a T30 "TORX" wrench, remove the 3 screws.
Remove the door lock through the service hole.
Be careful when removing the screws as the door lock may fall and become damaged.
69720B
14.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69760C
15.REMOVE FRONT DOOR INSIDE LOCKING LH CABLE ASSEMBLY