Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
74280
3.REMOVE REAR DOOR ARMREST BASE PANEL ASSEMBLY LH
69278C
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH
74611C
5.REMOVE ASSIST GRIP COVER LH
81230
6.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)
67604
7.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER LH
69340
9.REMOVE REAR DOOR LOCK ASSEMBLY LH
Using a T30 ''TORX'' socket, remove the 3 screws and door lock.
Be careful when removing the screws as the door lock may fall and become damaged.
69740D
10.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
69780B
11.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH