Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH (for Front) › from 2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255564 ENTRY LOCK AND UNLOCK SWITCH(for Front) A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH(for Front)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 69220 1.INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B433940

Pull and hold the bellcrank lever of the front door outside handle frame sub-assembly LH.


b.

Install the front door outside handle assembly LH by pushing it in the direction of the arrow in the illustration.


c.
B433941

Attach the 3 claws to install the connector and connector cove.


d.

Connect the connector.


Hide 69217D 2.INSTALL FRONT DOOR OUTSIDE HANDLE COVER

Hide 67832 3.INSTALL FRONT DOOR SERVICE HOLE COVER LH

Hide 67602 4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 81230 5.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 74646 6.INSTALL DOOR ASSIST GRIP COVER LH

Hide 69278B 7.INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 74232 8.INSTALL FRONT UPPER ARMREST BASE PANEL LH

Hide 67492A 9.INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 11.CHECK SRS WARNING LIGHT