Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH (for Front) › from 2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255564 ENTRY LOCK AND UNLOCK SWITCH(for Front) A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH(for Front)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67492A 2.REMOVE FRONT LOWER DOOR FRAME BRACKET GARNISH LH

Hide 74232 3.REMOVE FRONT UPPER ARMREST BASE PANEL LH

Hide 69278B 4.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 74646 5.REMOVE DOOR ASSIST GRIP COVER LH

Hide 81230 6.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 67602 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67832 8.REMOVE FRONT DOOR SERVICE HOLE COVER LH

Hide 69217D 9.REMOVE FRONT DOOR OUTSIDE HANDLE COVER

Hide 69220 10.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B433928

Using a screwdriver, detach the 2 claws of the connector cover in the direction indicated and disconnect the connector cover.

Text in Illustration
V100155

Protective Tape

HINT:

Tape the screwdriver tip before use.



b.
B433929

Using a screwdriver, detach the 2 claws of the connector in the direction indicated and disconnect the connector.

Text in Illustration
V100155

Protective Tape

HINT:

Tape the screwdriver tip before use.



c.
B433930

Detach the 2 claws and remove the holder in the direction indicated by the arrow in the illustration.


d.
B433931

Remove the front door outside handle assembly LH by sliding and pulling it in the direction indicated by the arrow in the illustration.

NOTICE:

If the release plate is not pulled and held when removing the front door outside handle assembly LH, the release plate will interfere with the front door outside handle assembly LH and become damaged.