Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH (for Rear) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255565 ENTRY LOCK AND UNLOCK SWITCH(for Rear) A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH(for Rear)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 69240 1.INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B183930

Insert the front end of the rear door outside handle assembly into the rear door outside handle frame.

NOTICE:

If the bellcrank lever is not pulled and held when installing the outside handle, the bellcrank lever will interfere with the outside handle and the release plate may be damaged.



b.

Insert the rear end of the rear door outside handle assembly into the rear door outside handle frame. Next, slide the rear door outside handle assembly toward the front of the vehicle to install it.


c.
B180934

Using a T30 ''TORX'' socket, tighten the screw.


d.

Connect the connector.


Hide 69227L 2.INSTALL REAR DOOR OUTSIDE HANDLE COVER LH

Hide 69340 3.INSTALL REAR DOOR LOCK ASSEMBLY LH

Hide 67842E 4.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 81230 5.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 67604 6.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 7.INSTALL ASSIST GRIP COVER LH

Hide 69278C 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 74280 9.INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).