Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH (for Rear) › from 2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255565 ENTRY LOCK AND UNLOCK SWITCH(for Rear) A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH(for Rear)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 69240 1.INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B436175

Install the rear door outside handle assembly LH.


b.

Connect the connector.


c.
B436176

Attach the 3 claws to install the connector and connector cover.


d.

Connect the connector.


Hide 69227L 2.INSTALL REAR DOOR OUTSIDE HANDLE COVER LH

Hide 69340 3.INSTALL REAR DOOR LOCK ASSEMBLY LH

Hide 67842E 4.INSTALL REAR DOOR SERVICE HOLE COVER LH

Hide 81230 5.INSTALL COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 67604 6.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 7.INSTALL ASSIST GRIP COVER LH

Hide 69278C 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

Hide 74272A 9.INSTALL REAR DOOR UPPER ARMREST BASE PANEL LH

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).