Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY LOCK AND UNLOCK SWITCH (for Rear) › from 2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255565 ENTRY LOCK AND UNLOCK SWITCH(for Rear) A

THEFT DETERRENT / KEYLESS ENTRY  ENTRY LOCK AND UNLOCK SWITCH(for Rear)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the LH side and RH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 74272A 2.REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH

Hide 69278C 3.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

Hide 74611C 4.REMOVE ASSIST GRIP COVER LH

Hide 81230 5.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 67604 6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 67842E 7.REMOVE REAR DOOR SERVICE HOLE COVER LH

Hide 69340 8.REMOVE REAR DOOR LOCK ASSEMBLY LH

Hide 69227L 9.REMOVE REAR DOOR OUTSIDE HANDLE COVER LH

Hide 69240 10.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

a.
B436167

Using a thin-bladed screwdriver, detach the 2 claws.

HINT:

Tape the thin-bladed screwdriver tip before use.


Text in Illustration
V100155

Protective Tape


b.
B436168

Using a thin-bladed screwdriver, detach the claw and disconnect the connector cover and connector.

Text in Illustration
V100155

Protective Tape


c.
B436169

Detach the 2 claw and disconnect the holder.


d.
B436170

Remove the rear door outside handle assembly LH by sliding and pulling it in the direction indicated by the arrow in the illustration.