Home › Vehicle Exterior › DOOR / HATCH › REAR DOOR › from 2015.08
RM2660E _59 Vehicle Exterior _052852 DOOR / HATCH _0255748 REAR DOOR A

DOOR / HATCH  REAR DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 75076 3.REMOVE REAR DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH (w/ Outside Moulding)

Hide 81230 4.REMOVE COURTESY LIGHT ASSEMBLY (w/ Courtesy Light)

Hide 69278C 5.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

a.
B180907

Using a screwdriver, detach the 4 claws and remove the rear door inside handle bezel LH.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
V100155

Protective Tape


Hide 74272A 6.REMOVE REAR DOOR UPPER ARMREST BASE PANEL LH

Hide 84810D 7.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

Hide 74611C 8.REMOVE ASSIST GRIP COVER LH

a.
B180910

Using a moulding remover, detach the 9 claws and remove the assist grip cover LH.


Hide 67604 9.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

a.
B310802E03
0.823,1.135 1.344,1.135 false 0.615,1.042 0.854,1.271 0.24,0.229 10 false (A) 2.219,1.385 2.458,1.615 0.24,0.229 10 false (1) 1.594,0.146 1.833,0.375 0.24,0.229 10 false (2)

Remove the 3 screws.


b.

Remove the 9 clips.


c.

Remove the rear inner door glass weatherstrip LH together with the rear door trim board sub-assembly LH by pulling them upward in the order shown in the illustration.

HINT:

Make sure that the pin labeled A in the illustration is detached from the door panel.



d.

Disconnect the connector and remove the rear door trim board sub-assembly LH.


e.
B180913

Disconnect the 2 cables from the rear door inside handle sub-assembly LH.


Hide 68174A 10.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP LH

a.
B310803

Detach the 4 clips and remove the rear door inner glass weatherstrip LH from the rear door trim board sub-assembly LH.

NOTICE:
·

Squeeze the metal clip to remove it.

·

The metal clip may be deformed if it is forcibly pulled.




Hide 82508 11.REMOVE REAR DOOR WIRING SUB-ASSEMBLY LH (w/ Illumination)

a.
B436162

Disconnect the connector.


b.

Detach the clamp and remove the rear door wiring sub-assembly LH.


Hide 69206C 12.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY LH

a.
B235658

Detach the 2 claws and remove the rear door inside handle sub-assembly LH.


Hide 69288A 13.REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

a.
B235659

Remove the 6 screws and rear door inside handle bezel LH.


Hide 86160Z 14.REMOVE REAR NO. 3 SPEAKER ASSEMBLY (for 14 Speakers)

Hide 86160C 15.REMOVE REAR SPEAKER SET (w/ Rear Speaker)

Hide 67842E 16.REMOVE REAR DOOR SERVICE HOLE COVER LH

a.
B436163

Using a clip remover, detach the 7clamps.


b.

Remove the bolt and disconnect the 3connectors.


c.

Remove the rear door service hole cover LH.

HINT:

Remove the remaining tape on the door.



Hide 67858B 17.REMOVE REAR DOOR PANEL PROTECTOR LH

a.
B180911

Detach the claw and remove the rear door panel protector LH.


Hide 68152C 18.REMOVE REAR DOOR GLASS RUN LH

a.
B180919

Remove the rear door glass run LH from the window frame.


Hide 67408F 19.REMOVE REAR DOOR REAR LOWER WINDOW FRAME SUB-ASSEMBLY LH

a.
B180920

Remove the 2 bolts.


b.

Remove the screw and rear door rear lower window frame sub-assembly LH.


Hide 68124C 20.REMOVE REAR DOOR QUARTER WINDOW GLASS LH

a.
B180923

Remove the rear door quarter window glass LH and rear door quarter window weatherstrip LH as a unit as shown in the illustration.


Hide 68189 21.REMOVE REAR DOOR QUARTER WINDOW WEATHERSTRIP LH

a.

Remove the rear door quarter window weatherstrip LH.


Hide 68104 22.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH

a.
B180921

Remove the rear door glass sub-assembly LH from the rear door window regulator sub-assembly LH as shown in the illustration.

NOTICE:

Do not damage the door glass.



Hide 69906B 23.REMOVE REAR DOOR GLASS CHANNEL SUB-ASSEMBLY LH (for Tempered Glass)

a.
B235660

Using a screwdriver, remove the rear door glass channel sub-assembly LH.

NOTICE:

Be careful not to damage the door glass.


HINT:

Tape the screwdriver tip before use.


Text in Illustration
V100155

Protective Tape


Hide 69975A 24.REMOVE REAR DOOR GLASS CHANNEL FILLER (for Tempered Glass)

a.

Remove the rear door glass channel filler.


Hide 67674A 25.REMOVE REAR DOOR FRAME GARNISH LH

a.
B180938

Detach the clip and remove the rear door frame garnish LH.

HINT:

This clip needs to be replaced with a new one because the clip will break when removing the rear door frame garnish LH.



Hide 67676C 26.REMOVE REAR DOOR NO. 2 FRAME GARNISH LH

a.
B184224

Detach the clip and remove the rear door No. 2 frame garnish LH.

HINT:

This clip needs to be replaced with a new one because the clip will break when removing the rear No. 2 door frame garnish LH.



Hide 69804 27.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

a.
B436164E06
2.458,0.604 2.729,0.365 false 2.74,0.24 2.938,0.479 0.198,0.24 10 true *a

Loosen the temporary bolt.

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator sub-assembly LH may fall and cause damage.


Text in Illustration
*a Temporary Bolt


b.

Remove the 3 bolts and rear door window regulator sub-assembly LH.

NOTICE:

Be careful when removing the bolts as the motor may fall and become damaged.



c.

Remove the temporary bolt from the rear door window regulator sub-assembly LH.


Hide 85720G 28.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

Hide 75740 29.REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH

Hide 75762A 30.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING LH

Hide 67836H 31.REMOVE REAR DOOR LOCK CHILD PROTECTION COVER LH

Hide 69340 32.REMOVE REAR DOOR LOCK ASSEMBLY LH

Hide 69740D 33.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

a.
B180928

Using a screwdriver, detach the claw.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
V100155

Protective Tape


b.
B180929

Remove the rear door lock remote control cable assembly LH.


Hide 69780B 34.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH

a.
B180930

Using a screwdriver, detach the 3 claws.

HINT:

Tape the screwdriver tip before use.


Text in Illustration
V100155

Protective Tape


b.
B188530E03
0.135,2.426 0.392,2.624 0.257,0.198 10 *B 0.135,0.103 0.392,0.301 0.257,0.198 10 *A

Remove the rear door inside locking cable assembly LH.

Text in Illustration
*A w/o Double Lock
*B w/ Double Lock


Hide 69227L 35.REMOVE REAR DOOR OUTSIDE HANDLE COVER LH

a.
B436165

Using a T30 ''TORX'' socket, loosen the screw.


b.
B436166

Detach the claw and remove the rear door outside handle cover LH.


Hide 69240 36.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY LH

a.

w/ Entry and Start System:

i.
B436167

Using a thin-bladed screwdriver, detach the 2 claws.

HINT:

Tape the thin-bladed screwdriver tip before use.


Text in Illustration
V100155

Protective Tape



b.
B436169

Detach the 2 claw and disconnect the holder.


c.
B436170

Remove the rear door outside handle assembly LH by sliding and pulling it in the direction indicated by the arrow in the illustration.


Hide 69252B 37.REMOVE REAR DOOR NO. 1 OUTSIDE HANDLE PAD LH

a.
B155811

Detach the 3 claws and remove the rear door No. 1 outside handle pad LH.


Hide 69254B 38.REMOVE REAR DOOR NO. 2 OUTSIDE HANDLE PAD LH

a.
B180939

Detach the 2 claws and remove the rear door NO. 2 outside handle pad LH.


Hide 69204A 39.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY LH

a.
B436171

w/ Entry and Start System:

i.

Detach the clamp.



b.

Using a T30 ''TORX'' socket, loosen the "TORX" screw.


c.
B436172E07
0.365,2.229 0.365,1.615 0.365,1.615 0.698,1.615 false 0.406,2.573 0.406,3.094 0.406,3.094 0.573,3.094 false 2.125,2.521 2.125,3.083 2.125,3.083 1.948,3.083 false 0.74,1.531 0.948,1.74 0.208,0.208 10 true *b 0.583,3.01 0.844,3.25 0.26,0.24 10 true *b 1.75,2.99 1.938,3.219 0.188,0.229 10 true *a

Detach the nut and 2 guides and remove the rear door outside handle frame sub-assembly LH.

Text in Illustration
*a Nut
*b Guide


d.

Slide the rear door outside handle frame sub-assembly LH and No. 4 electrical key wire harness to remove them.

HINT:

Remove the rear door outside handle frame sub-assembly LH through the service hole.



e.

Remove the lock open rod from the rear door outside handle frame sub-assembly LH.


Hide 89746F 40.REMOVE NO. 4 ELECTRICAL KEY WIRE HARNESS (w/ Entry and Start System)

a.
B436173

Detach the 2 clamps, and remove the No. 4 electrical key wire harness from the rear door outside handle frame sub-assembly LH.


Hide 68640A 41.REMOVE REAR DOOR CHECK ASSEMBLY LH

a.
B155817

Remove the bolt, 2 nuts and rear door check assembly LH.

NOTICE:

Be careful when removing the bolt and nuts as the rear door check assembly LH may fall and become damaged.


HINT:

Remove the rear door check assembly LH through the service hole.



Hide 67872 42.REMOVE REAR DOOR WEATHERSTRIP LH

a.

Detach the 21 clips and remove the rear door weatherstrip LH.

B309316E02
2.771,1.75 3.146,1.75 false 0.073,0 0.563,0.302 0.49,0.302 10 false *A 3.875,0 4.365,0.302 0.49,0.302 10 false *B 3.167,1.667 3.51,1.969 0.344,0.302 10 false *1

Text in Illustration
*A w/ Spot Cover *B w/o Spot Cover
*1 Double-sided Tape - -