Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (w/ Entry and Start System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255571 THEFT DETERRENT SYSTEM(w/ Entry and Start System) J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/ Entry and Start System)  IG Power Source Circuit  


DESCRIPTION

When the engine switch is turned on (IG), positive (+) battery voltage is applied to the certification ECU (smart key ECU assembly).


WIRING DIAGRAM

B159040E02
5.122,1.846 5.441,1.989 0.318,0.143 10 E29 5.185,1.412 5.392,1.556 0.207,0.143 10 E 5.185,0.772 5.392,0.915 0.207,0.143 10 IG 4.877,0.657 5.077,0.800 0.200,0.143 10 18 3.713,0.924 4.010,1.067 0.297,0.143 10 IGN 1.492,0.652 2.197,0.971 0.705,0.318 10 from IG2 Relay 4.877,1.277 5.077,1.420 0.200,0.143 10 17 5.122,2.01 6.692,2.342 1.570,0.332 10 Certification ECU (Smart Key ECU Assembly)

PROCEDURE

1.CHECK BASIC FUNCTION (POWER SOURCE MODE FUNCTION)
a.

Check the basic function of the power source mode function.

OK:

Basic function operates normally.




OK

2.INSPECT FUSE (IGN)

NG

2.INSPECT FUSE (IGN)
a.

Remove the IGN fuse from the engine room relay block.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
IGN fuse Always Below 1 Ω




OK

3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU [SMART KEY ECU ASSEMBLY] - BATTERY AND BODY GROUND)
U164112E02
0.198,2.781 0.302,2.323 true 3.229,2.688 3.125,2.156 true 0.135,2.771 0.313,2.969 0.177,0.198 10 false IG 3.188,2.74 3.313,2.938 0.125,0.198 10 false E 0.073,0.063 2.969,0.656 2.896,0.594 10 false Front view of wire harness connector: (to Certification ECU [Smart Key ECU Assembly]) 0.292,1.427 0.615,1.625 0.323,0.198 10 false E29

a.

Disconnect the E29 ECU connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E29-17 (E) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
E29-18 (IG) - Body ground Engine switch on (IG) 11 to 14 V




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR