Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM(for Start Function) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255570 ENTRY AND START SYSTEM(for Start Function) Y

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the push-button start function.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Result
NEXT



NEXT

3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
3.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Using the intelligent tester, check if the CAN communication system is functioning normally.

·

For LHD vehicles, use the following procedures.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

·

For RHD vehicles, use the following procedures.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM


Result:
Result Proceed to
DTC is not output A
DTC is output (for LHD) B
DTC is output (for RHD) C




A

4.CHECK FOR DTC*

B

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

C

GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

4.CHECK FOR DTC*

b.

Clear the DTCs.


c.

Check whether the same DTC(s) relevant to the SFI system, EDU system or entry and start system recurs by reproducing the symptoms indicated by the noted DTC(s) in the first step above.

Result:
Result Proceed to
DTC output does not reoccur A
SFI system DTC output reoccurs (for 1GR-FE) B
SFI system DTC output reoccurs (for 1UR-FE) C
SFI system DTC output reoccurs (for 3UR-FE) D
ECD system DTC output reoccurs (for 1VD-FTV w/o DPF) E
ECD system DTC output reoccurs (for 1VD-FTV w/ DPF) F
Entry and start system DTC output reoccurs G




A

5.PROBLEM SYMPTOMS TABLE

B

GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

C

GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

D

E

F

G

7.ADJUST, REPAIR OR REPLACE
5.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END