Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM (w/ Entry and Start System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052839 THEFT DETERRENT / KEYLESS ENTRY _0255571 THEFT DETERRENT SYSTEM(w/ Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM(w/ Entry and Start System)  B2761  Intrusion Sensor Internal Circuit Malfunction  


DESCRIPTION

The intrusion sensor (theft warning ultrasonic sensor) conducts self-diagnosis immediately after power is supplied to the sensor (when the theft deterrent system is set).

If a problem is detected in the signals transmitted and received by the intrusion sensor (theft warning ultrasonic sensor), or if the transmission or reception circuits malfunction, the intrusion sensor (theft warning ultrasonic sensor) transmits a signal to the certification ECU (smart key ECU assembly). The certification ECU (smart key ECU assembly) then stores this DTC.


DTC Code DTC Detection Condition Trouble Area
B2761 Intrusion sensor outputs signal for sensor malfunction
·

Map light assembly

·

Certification ECU (smart key ECU assembly)



PROCEDURE

1.CHECK FOR DTC
a.

Set the theft deterrent system and check if the same DTC is not output.

OK:

DTC B2761 is not output.




OK

NG

2.CHECK MAP LIGHT ASSEMBLY (OPERATION)
2.CHECK MAP LIGHT ASSEMBLY (OPERATION)
a.

Temporarily replace the map light with a new or normally functioning one (See page Vehicle Interior>LIGHTING (INT)>ROOM LIGHT(for Front)>REMOVAL).


b.

Check if DTC B2761 is not output.

OK:

DTC B2761 is not output.




OK

END (MAP LIGHT ASSEMBLY IS FAULTY)

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)