When the back door entry lock and unlock functions do not operate, one of the following may be malfunctioning: 1) power door lock control system, or 2) electrical key antenna (for outside luggage compartment), or 3) main body ECU (cowl side junction block LH), or 4) certification ECU (smart key ECU assembly).
Before performing the inspection, check that there are no problems related to the "CAN Communication System" and "LIN Communication System".
When the door control switch of the master switch assembly is operated, check that the locked doors unlock.
Door locks operate normally.
OK
NG
(See pageVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Check if the power back door is equipped on the vehicle.
| Result | Proceed to |
|---|---|
| w/ Power Back Door System | A |
| w/o Power Back Door System | B |
A
B
When the power back door switch is operated, check that the power back door open and close.
Power back door system is normal.
| Result | Proceed to |
|---|---|
| Power back door system is abnormal | A |
| Power back door system is normal | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Main Body / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item / Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Back Lock Pos switch | Back door lock position switch signal / ON or OFF | ON: Back door is unlocked
OFF: Back door is locked |
- |
On the intelligent tester screen, the display changes between ON and OFF as shown in the chart above.
OK
NG
Using the intelligent tester, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Back Door Handle SW | Back door open switch / ON or OFF | ON: Back door open switch is pushed
OFF: Back door open switch is not pushed |
- |
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Tr/B-Door Lock SW | Back door lock switch / ON or OFF | ON: Back door lock switch is pushed
OFF: Back door lock switch is not pushed |
- |
"ON" (switch is pushed) and "OFF" (switch is not pushed) appears on the screen.
OK
NG
Disconnect the E29 ECU connector.
Disconnect the K23 antenna connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E29-31 (CLG8) - K23-1 (CLG5) | Always | Below 1 Ω |
| E29-32 (CG8B) - K23-2 (CLGB) | Always | Below 1 Ω |
| E29-31 (CLG8) - Body ground | Always | 10 kΩ or higher |
| E29-32 (CG8B) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the back door electrical key antenna (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ELECTRICAL KEY OSCILLATOR(for Outside Luggage Compartment)>REMOVAL).
NEXT
Check that the entry functions operate normally.
Entry functions operate normally.
OK
NG
Disconnect the S7 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| S7-2 (L) - Body ground | Always | Below 1 Ω |
OK
NG