Use these procedures to troubleshoot the power door lock control system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output (for LHD) | B |
| CAN DTC is output (for RHD) | C |
A
B
Click here NETWORKING > CAN COMMUNICATION SYSTEM (for LHD) > DIAGNOSTIC TROUBLE CODE CHART
C
Click here NETWORKING > CAN COMMUNICATION SYSTEM (for RHD) > DIAGNOSTIC TROUBLE CODE CHART
Use the intelligent tester to check if the LIN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| LIN DTC is not output | A |
| LIN DTC is output | B |
A
B
Refer to problem symptoms table.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Operation Check.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
Terminals of ECU.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>TERMINALS OF ECU
Data List / Active Test.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>DATA LIST / ACTIVE TEST
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT