Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER(w/ Multi-information Display) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052841 METER / GAUGE / DISPLAY _0255595 COMBINATION METER(w/ Multi-information Display) A

METER / GAUGE / DISPLAY  COMBINATION METER(w/ Multi-information Display)  INSTALLATION  


PROCEDURE

Hide 83100 1.INSTALL COMBINATION METER ASSEMBLY

a.
E155135

Connect the connectors.


b.
E154733

Install the combination meter with the 4 screws.


Hide 55404C 2.INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

a.
E155437

Connect the connector.


b.
E154732

Attach the 9 claws to install the finish panel.


c.
E155398

Attach the 4 claws.


Hide 55475A 3.INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

a.
E155136

Attach the 2 claws to install the panel garnish.


Hide 55403C 4.INSTALL LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

a.
E154742

Connect the connectors and 2 clamps.


b.

Attach the 8 claws to install the panel pad.


c.

Install the screw.


d.

Install the clip.


Hide 55449C 5.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

a.
E155134

Attach the 7 claws to install the panel cushion.


Hide 55474C 6.INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

a.
E155133

Attach the 3 claws to install the panel garnish.


Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
·

Reset the Autoaway/Return function setting to the previous condition by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).