Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052841 METER / GAUGE / DISPLAY _0255598 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Voltage Meter Malfunction  


DESCRIPTION

The voltmeter indicates the voltage applied to the IG+ terminal of the combination meter.

WIRING DIAGRAM

E200513E07
0.719,1.042 2.115,1.208 1.396,0.167 10 false from IG2 MAIN Relay 3.125,1.188 3.667,1.354 0.542,0.167 10 false METER 4.313,2.74 4.708,2.938 0.396,0.198 10 false E119 4.188,0.938 4.385,1.125 0.198,0.188 10 false 22 4.177,1.99 4.375,2.177 0.198,0.188 10 false 20 4.448,0.927 4.708,1.094 0.26,0.167 10 false IG+ 4.448,2 4.656,2.156 0.208,0.156 10 false ET 5.708,1.76 6.094,1.906 0.385,0.146 10 false VOLT 4.313,2.927 6.167,3.104 1.854,0.177 10 false Combination Meter Assembly

PROCEDURE

1.INSPECT FUSE (METER)
a.

Remove the METER fuse from the engine room relay block.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
METER fuse Always Below 1 Ω




OK

2.PERFORM ACTIVE TEST USING GTS (VOLTMETER)

NG

REPLACE FUSE

2.PERFORM ACTIVE TEST USING GTS (VOLTMETER)
a.

Operate the GTS according to the display and select Active Test (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Volt meter Operation Voltmeter 0, 3, 6, 9, 12, 15, or 18 Perform the test with the vehicle stopped and engine idling.

OK:

Needle indication is normal.




OK

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)

NG

REPLACE COMBINATION METER ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (COMBINATION METER - BATTERY AND BODY GROUND)
a.

Disconnect the E119meter connector.


b.

Measure the resistance and voltage according to the value(s) in the tables below.

Standard Resistance:
Tester Connection Condition Specified Condition
E119-20 (ET) - Body ground Always Below 1 Ω


Standard Voltage:
Tester Connection Switch Condition Specified Condition
E119-22 (IG+) Ignition switch ON 11 to 14 V
Ignition switch off Below 1 V




OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR