Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255605 SPIRAL CABLE G

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE  INSPECTION  


PROCEDURE

Hide 1.INSPECT SPIRAL CABLE

a.

If there are any defects as mentioned below, replace the spiral cable with a new one:

Scratches, cracks, dents or chips on the connector or the spiral cable.


b.
B449536E01
0.094,1.406 0.313,1.625 0.219,0.219 0.885,2.49 1.104,2.708 0.219,0.219 1.802,0.938 2.115,1.135 0.313,0.198 2.26,0.938 2.573,1.135 0.313,0.198 1.469,4.281 1.781,4.479 0.313,0.198 2.302,4.281 2.615,4.479 0.313,0.198 0.24,1.021 0.958,1.219 0.719,0.198 10 false ORANGE 1.063,1.531 1.781,1.729 0.719,0.198 10 false BLACK 0.156,1.427 0.354,1.635 0.198,0.208 10 false B 0.948,2.5 1.146,2.708 0.198,0.208 10 false A 1.833,0.948 2.115,1.177 0.281,0.229 10 false z36 2.313,0.948 2.594,1.177 0.281,0.229 10 false z37 1.51,4.292 1.792,4.521 0.281,0.229 10 false E12 2.333,4.292 2.615,4.521 0.281,0.229 10 false E13

Check the spiral cable.

i.

Set the spiral cable to the center position (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION).


ii.

Measure the resistance between each terminal of the spiral cable according to the table below.


iii.

After setting the spiral cable to the center position, rotate the spiral cable 2.5 times clockwise, and measure the resistance as shown. Then rotate the spiral cable 5 times counterclockwise, and measure the resistance as shown.

Standard Resistance:
Tester Connection Condition Specified Condition
E13-1 - B2 Always Below 1 Ω
E13-2 - B1 Always Below 1 Ω
E13-3 - A1 Always Below 1 Ω
E13-4 - A2 Always Below 1 Ω
E12-6 - z36-10 Always Below 1 Ω
E12-5 - z36-9 Always Below 1 Ω
E12-4 - z36-8 Always Below 1 Ω
E12-3 - z36-7 Always Below 1 Ω
E12-2 - z36-6 Always Below 1 Ω
E12-2 - z37-4 Always Below 1 Ω
E12-1 - z37-3 Always Below 1 Ω
E12-12 - z36-5 Always Below 1 Ω
E12-11 - z36-4 Always Below 1 Ω
E12-10 - z36-3 Always Below 1 Ω
E12-9 - z36-2 Always Below 1 Ω
E12-8 - z36-1 Always Below 1 Ω
E12-8 - z37-2 Always Below 1 Ω
E12-7 - z37-1 Always Below 1 Ω



iv.

After setting the spiral cable to the center position, rotate the spiral cable 2.5 times clockwise. Then while rotating the spiral cable 5 times counterclockwise, measure the resistance as shown.

Standard Resistance:
Tester Connection Condition Specified Condition
E13-1 - B2 Always Below 1 Ω
E13-2 - B1 Always Below 1 Ω
E13-3 - A1 Always Below 1 Ω
E13-4 - A2 Always Below 1 Ω
E12-6 - z36-10 Always Below 1 Ω
E12-5 - z36-9 Always Below 1 Ω
E12-4 - z36-8 Always Below 1 Ω
E12-3 - z36-7 Always Below 1 Ω
E12-2 - z36-6 Always Below 1 Ω
E12-2 - z37-4 Always Below 1 Ω
E12-1 - z37-3 Always Below 1 Ω
E12-12 - z36-5 Always Below 1 Ω
E12-11 - z36-4 Always Below 1 Ω
E12-10 - z36-3 Always Below 1 Ω
E12-9 - z36-2 Always Below 1 Ω
E12-8 - z36-1 Always Below 1 Ω
E12-8 - z37-2 Always Below 1 Ω
E12-7 - z37-1 Always Below 1 Ω


NOTICE:

As the spiral cable may break, do not rotate the spiral cable more than the specified amount.