Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255613 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH and LH.

·

The procedures listed below are the LH side.



PROCEDURE

Hide 1.INSTALL SIDE AIRBAG SENSOR

a.
B181765

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Install the side airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




d.

Check that there is no looseness in the installation parts of the side airbag sensor.


e.

Connect the connector.


Hide 67602 2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

Hide 74611C 3.INSTALL ASSIST GRIP COVER LH

Hide 84040 4.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY

Hide 69278B 5.INSTALL FRONT DOOR INSIDE HANDLE BEZEL LH

Hide 67492A 6.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

Hide 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.CHECK SRS WARNING LIGHT