Use the same procedures for the RH and LH.
The procedures listed below are the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67492A
2.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH
69278B
3.REMOVE FRONT DOOR INSIDE HANDLE BEZEL LH
84040
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
74611C
5.REMOVE ASSIST GRIP COVER LH
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
7.REMOVE SIDE AIRBAG SENSOR
Disconnect the connector.
Remove the bolt and side airbag sensor.