Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
2.REMOVE REAR NO. 2 SEAT ASSEMBLY LH
Remove the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(except Face to Face Seat Type)>REMOVAL).
3.REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Split Bench Seat Type)
Remove the rear No. 2 seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 2 SEAT ASSEMBLY(for Face to Face Seat Type)>REMOVAL).
58574A
4.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/ Sliding Roof)
58574A
5.REMOVE REAR FLOOR MAT REAR SUPPORT PLATE (w/o Sliding Roof)
51775
6.REMOVE REAR STEP COVER (w/ Sliding Roof)
51775
7.REMOVE REAR STEP COVER (w/o Sliding Roof)
67918E
8.REMOVE REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)
67918E
9.REMOVE REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)
71845B
10.REMOVE REAR SEAT COVER CAP (w/ Sliding Roof)
71845B
11.REMOVE REAR SEAT COVER CAP (w/o Sliding Roof)
62520P
12.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/ Sliding Roof)
62520P
13.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH (w/o Sliding Roof)
14.REMOVE REAR AIRBAG SENSOR
Remove the bolt and rear airbag sensor.
Disconnect the connector.