Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SEAT POSITION SENSOR › from 2015.08
RM2660E _58 Vehicle Interior _052843 SUPPLEMENTAL RESTRAINT SYSTEMS _0255616 SEAT POSITION SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SEAT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL SEAT POSITION SENSOR

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
U133202E04
0.594,1.792 0.698,1.917 0.698,1.917 0.833,1.917 false 1.583,0.083 2.958,0.281 1.375,0.198 10 false Seat Position Sensor 2.406,0.438 3.292,0.635 0.885,0.198 10 false Feeler Gauge 2.448,1.271 3.01,1.469 0.563,0.198 10 false 1.0 mm 0.885,1.844 1.604,2.042 0.719,0.198 10 false Seat Rail

Using a 1.0 mm (0.0393 in.) feeler gauge, install the seat position sensor.

NOTICE:
·

If the seat position sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position sensor with a new one.

·

When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.



HINT:

Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 1.4 mm (0.0236 to 0.0551 in.).



d.

Using a T30 "TORX" socket wrench, install the seat position sensor with the screw.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


e.

Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 to 1.4 mm (0.0236 to 0.0551 in.).


f.

Check that there is no looseness in the installation parts of the seat position sensor.


g.

Connect the connector.


h.

Install the seat slide position sensor protector to the seat position sensor.


Hide 2.INSTALL FRONT SEAT ASSEMBLY LH

Hide 3. CHECK SRS WARNING LIGHT