Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255621 PRE-CRASH SAFETY SYSTEM U

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Pre-Crash / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Pre-Crash
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Driver Buckle SW Driver side buckle switch status / UNSET, SET or NG UNSET: Driver side seat belt unfastened
SET: Driver side seat belt fastened
NG: Indeterminate data
-
Passenger Buckle SW Front passenger side buckle switch status / UNSET, SET or NG UNSET: Passenger side seat belt unfastened
SET: Passenger side seat belt fastened
NG: Indeterminate data
-
Driver Belt Control Seat belt control status of driver side seat / STOP, ON or ERROR STOP: Control stopped
ON: Controlled
ERROR: Indeterminate data
Driver side seat belt is fastened
Passenger Belt Control Seat belt control status of passenger side seat / STOP, ON or ERROR STOP: Control stopped
ON: Controlled
ERROR: Indeterminate data
Passenger side seat belt is fastened
Number of Trouble Codes Number of present trouble codes / Min.: 0, Max.: 255 Number of DTCs present -



PERFORM ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: All ECUs / (desired menu) / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Pre-Crash
Tester Display Test Part Control Range Diagnostic Note
Driver Seat Belt Motor Driver side seat belt motor OFF or ON Driver side seat belt is fastened
Passenger Seat Belt Motor Passenger side seat belt motor OFF or ON Passenger side seat belt is fastened
Driver and Passenger Seat Belt Motor Driver and passenger side seat belt motors OFF or ON Driver and passenger side seat belts are fastened

ABS/VSC/TRAC
Tester Display Test Part Control Range Diagnostic Note
Buzzer Skid control buzzer sounds OFF or ON -