The seat belt control ECU receives signals from the master cylinder solenoid (skid control ECU) and the center airbag sensor via the CAN communication line.
The distance control ECU receives signals from the ECM via the CAN communication line.
| DTC Code | DTC Detection Item | Inspection Area |
|---|---|---|
| U0100 | ECM communication error. | ·
CAN communication system ·
Distance control ECU ·
ECM |
| U0122 | Skid control ECU communication error. | ·
CAN communication system ·
Master cylinder solenoid (skid control ECU) ·
Seat belt control ECU |
| U0151 | Center airbag sensor communication error. | ·
CAN communication system ·
Seat belt control ECU ·
Center airbag sensor |
| U1101 | Distance control ECU communication error. | ·
CAN communication system ·
Distance control ECU ·
Seat belt control ECU |
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING for LHD, Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING for RHD).
| Result | Proceed to |
|---|---|
| OK
(DTC is not output) |
A |
| NG
(for LHD) |
B |
| NG
(for RHD) |
C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C