Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255621 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1AA0  Front Camera Module Circuit  


DESCRIPTION

The driving support ECU assembly receives information about the area in front of the vehicle from the forward recognition camera. If the driving support ECU assembly detects a malfunction in the forward recognition camera, it stores DTC C1AA0.

DTC No. DTC Detection Condition Trouble Area
C1AA0 While the engine switch is on (IG), the forward recognition camera detects an internal malfunction for approximately 5 seconds or more.
·

Forward recognition camera system

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust (See page (See page Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT). If the system is turned on without performing Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust, DTC C1AA9 will be stored.

·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.




PROCEDURE

1.CHECK DTC OUTPUT (FORWARD RECOGNITION CAMERA SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.



Result
Result Proceed to
Forward recognition camera system DTCs are not output A
Forward recognition camera system DTCs are output B


A

2.CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)

B

2.CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.



f.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.




Result
Result Proceed to
DTC C1AA0 is not output A
DTC C1AA0 is output B


A

B

REPLACE DRIVING SUPPORT ECU ASSEMBLY