Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255621 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1AA9  Front Camera Module Beam Axis Not Adjusted  


DESCRIPTION

Also if Recognition Camera Axis Adjust has not been performed or did not complete normally after the forward recognition camera was replaced with a new one, it stores DTC C1AA9.

DTC No. DTC Detection Condition Trouble Area
C1AA9 When the pre-crash safety system is operating, the driving support ECU assembly detects that Recognition Camera Axis Adjust has not been completed.
·

Forward recognition camera system

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust (See page (See page Engine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT). If the system is turned on without performing Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust, DTC C1AA9 will be stored.

·

First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.




PROCEDURE

1.CHECK DTC OUTPUT (FORWARD RECOGNITION CAMERA SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Enter the following menus: Chassis / Front Recognition Camera / Trouble Codes.



Result
Result Proceed to
Forward recognition camera system DTCs are not output A
Forward recognition camera system DTCs are output B

HINT:

When any forward recognition camera system DTCs are stored, the forward recognition camera system is malfunctioning. Perform troubleshooting for the forward recognition camera system first.



A

2.CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)

B

2.CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.



e.

Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.



f.

Check for DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC C1AA9 is output A
DTC C1AA9 isnot output B



A

REPLACE DRIVING SUPPORT ECU ASSEMBLY

B