Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM CANCEL SWITCH › from 2015.08
RM2660E _58 Vehicle Interior _052844 PRE-CRASH SAFETY _0255622 PRE-CRASH SAFETY SYSTEM CANCEL SWITCH G

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM CANCEL SWITCH  INSPECTION  


PROCEDURE

Hide 84770A 1.INSPECT PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY

a.
B410812E03
1.333,1.313 0.646,1.719 true 1.552,1.323 1.333,1.729 true 1.76,1.323 1.938,1.719 true 2,1.323 2.813,1.719 true 0.458,1.75 0.792,1.948 0.333,0.198 10 false ECU 2.646,1.75 2.979,1.948 0.333,0.198 10 false GND 1.156,1.75 1.521,1.969 0.365,0.219 10 false ILL+ 1.833,1.76 2.198,1.979 0.365,0.219 10 false ILL- 0.083,0.125 0.323,0.365 0.24,0.24 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance
Tester Connection Switch Condition Specified Condition
8 (ECU) - 5 (GND) Pre-crash system cancel switch not pressed 10 kΩ or higher
Pre-crash system cancel switch pressed Below 1 Ω

If the result is not as specified, replace the pre-crash system cancel switch assembly.

Text in Illustration
*a Component without harness connected
(Pre-crash System Cancel Switch Assembly)


b.

Apply battery voltage to the pre-crash system cancel switch assembly and check that it illuminates.

OK
Tester Connection Switch Condition
Battery positive (+) → Terminal 7 (ILL+) Battery negative (-) → Terminal 6 (ILL-) Illuminates

If the result is not as specified, replace the pre-crash system cancel switch assembly.