Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052845 SEAT _0255624 FRONT SEAT ASSEMBLY(for Manual Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Manual Seat)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 71200S 1.INSTALL FRONT SEAT ASSEMBLY LH

a.

Place the front seat assembly LH in the cabin.

NOTICE:

Be careful not to damage the vehicle body.



b.

w/ Wire Harness:

Connect the connectors under the front seat assembly LH.


c.

Temporarily install the front seat assembly LH with the 4 bolts.


d.

Operate the seat track adjusting handle to move the front seat assembly LH to the rearmost position.


e.
B188505E01
0.919,0 1.061,0.205 0.142,0.205 10 1 1.872,1.471 2.004,1.675 0.132,0.205 10 2

Tighten the bolts in the order indicated in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


f.

Operate the seat track adjusting handle to move the front seat assembly LH to the foremost position.


g.
B188506E01
0.533,1.524 0.643,1.707 0.111,0.184 10 1 2.696,1.483 2.810,1.667 0.114,0.184 10 2

Tighten the bolts in the order indicated in the illustration.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


h.

w/ Front Seat Side Airbag:

Connect the cable to the negative (-) battery terminal.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)



i.

for Power Tilt and Power Telescopic Steering Column:

Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter (See page General>INTRODUCTION>REPAIR INSTRUCTION>CUSTOMIZE PARAMETERS)


Hide 72158A 2.INSTALL REAR INNER SEAT TRACK BRACKET COVER LH

B180785

a.

Attach the 3 claws to install the rear inner seat track bracket cover LH.


Hide 72138J 3.INSTALL REAR OUTER FRONT SEAT TRACK COVER LH

B180784

a.

Attach the 3 claws to install the rear outer front seat track cover LH.


Hide 72128A 4.INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH

B180783

a.

Attach the 2 claws to install the front inner seat track bracket cover LH.


Hide 72124 5.INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH

B180782

a.

Attach the 2 claws to install the front outer seat track bracket cover LH.


Hide 71910A 6.INSTALL FRONT SEAT HEADREST ASSEMBLY

a.

Install the front seat headrest assembly.


Hide 7.CHECK SRS WARNING LIGHT (w/ Front Seat Side Airbag)

Hide 8.INSPECT FRONT SEAT ASSEMBLY (w/ Lumbar Support)

a.

Check the lumbar support operation.

i.

Operate the lumbar switch and check that the lumbar support moves in both directions.