When a signal is input into the front power seat switch LH*1, RH*2, the built-in ECU manages the signals received from the front power seat switch, and operates each motor. If the front power seat switch LH*1, RH*2 receives more than 2 motor operation signals for the same motor, the motor will be stopped. Manual operation is restarted when the front power seat switch LH*1, RH*2 receives 1 signal only.
*1: for LHD
*2: for RHD
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check that each function of the power seat operates normally by using the front power seat switch LH*1, RH*2 (See page Vehicle Interior>SEAT>FRONT POWER SEAT CONTROL SYSTEM (w/ Seat Position Memory System)>OPERATION CHECK).
*1: for LHD
*2: for RHD
| Result | Proceed to |
|---|---|
| All power seat functions do not operate | A |
| One or more power seat functions do not operate | B |
A
B
Disconnect the c39*1, c46*2 and c40*1, c47*2 switch connectors.
*1: for LHD
*2: for RHD
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| c39-6 (+B) - Body ground | Always | 11 to 14 V |
| c40-12 (SYSB) - Body ground | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| c46-6 (+B2) - Body ground | Always | 11 to 14 V |
| c47-12 (SYSB) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| c39-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| c46-1 (GND) - Body ground | Always | Below 1 Ω |
OK
NG