Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
84921B
1.REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a screwdriver, detach the 2 claws and remove the slide and vertical power seat switch knob.
Tape the screwdriver tip before use.
84921A
2.REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.
| *1 | Protective Tape |
Tape the screwdriver tip before use.
71812D
3.REMOVE FRONT SEAT CUSHION SHIELD LH
Remove the 2 screws.
Disconnect the 2 rubber bands.
Remove the 3 screws.
Detach the 2 claws and remove the front seat cushion shield LH together with the front inner No. 1 seat cushion shield LH.
for Driver Side:
Disconnect the connector.
71868A
4.REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD LH
Remove the screw.
Detach the claw and remove the front inner No. 1 seat cushion shield LH from the front seat cushion shield LH.
84920
5.REMOVE LUMBAR SWITCH (for Driver Side)
Remove the 2 screws and lumbar switch from the front seat cushion shield LH.
73240
6.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
71862
7.REMOVE FRONT INNER SEAT CUSHION SHIELD LH
Remove the screw.
Detach the 2 claws and clip, and then remove the front inner seat cushion shield LH.
84922C
8.REMOVE FRONT POWER SEAT SWITCH LH
w/ Seat Position Memory System:
Disconnect the 2 connectors.
w/o Seat Position Memory System:
Disconnect the connector.
Remove the 3 screws and front power seat switch LH.
9.REMOVE SEAT CUSHION COVER WITH PAD
Using a clip remover, remove the 2 clips.
w/o Climate Control Seat System:
Disconnect the connector and detach the 2 wire harness clamps.
Disconnect the connector and detach the wire harness clamp.
w/ Climate Control Seat System:
Disconnect the 2 connectors and detach the 4 wire harness clamps.
Detach the wire harness clamp.
for Front Passenger Side:
Disconnect the connector.
Detach the 2 clamps and remove the connector holder.
Bend the 2 seat frame claws upward.
Detach the hooks and remove the seat cushion cover with pad.
71072S
10.REMOVE FRONT SEPARATE TYPE SEAT CUSHION COVER
Remove the hog rings and front separate type seat cushion cover from the front separate type seat cushion pad.
87510L
11.REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)
w/o Climate Control Seat System:
Cut off the tack pins and remove the front seat cushion heater assembly LH from the front separate type seat cushion cover.
w/ Climate Control Seat System:
Cut off the tack pins and remove the front seat cushion heater assembly LH from the front separate type seat cushion cover.
86295
12.REMOVE TELEVISION BASE (w/ Rear Entertainment System)
86680A
13.REMOVE TELEVISION DISPLAY ASSEMBLY (w/ Rear Entertainment System)
71706
14.REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH
Remove the 2 screws.
Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 hooks and remove it.
81080R
15.REMOVE NO. 1 INTERIOR ILLUMINATION LAMP ASSEMBLY RH (w/ Illumination)
Detach the 2 claws and remove the No. 1 interior illumination lamp assembly RH.
79121
16.REMOVE NO. 1 SEAT CUSHION BRACKET (w/ Illumination)
Detach the 2 claws and remove the No. 1 seat cushion bracket.
85865
17.REMOVE SEAT CLIMATE CONTROL CONTROLLER LH (w/ Climate Control Seat System, for Seatback)
Detach the 2 claws and disconnect the seat climate control blower LH.
Detach the 4 hooks and remove the seat climate control controller LH.
71931
18.REMOVE FRONT SEAT HEADREST SUPPORT
Detach the 4 claws and remove the 2 front seat headrest supports.
19.REMOVE SEATBACK COVER WITH PAD
Remove the hog rings.
| *1 | Hog Ring |
Remove the nut and detach the seatback cover bracket.
| *1 | Seatback Cover Bracket |
Detach the hooks and remove the seatback cover with pad.
71074S
20.REMOVE FRONT SEPARATE TYPE SEATBACK COVER
Pass the seatback cover bracket through the hole of the front separate type seatback pad.
| *1 | Seatback Cover Bracket |
Remove the hog rings.
Detach the fastening tape and remove the front separate type seatback cover from the front separate type seatback pad.
| *1 | Fastening Tape |
71074S
21.REMOVE FRONT SEPARATE TYPE SEATBACK COVER (w/ Climate Control Seat System)
Pass the seatback cover bracket through the hole of the front separate type seatback pad.
| *1 | Seatback Cover Bracket |
Remove the hog rings and front separate type seatback cover from the front separate type seatback pad.
87510N
22.REMOVE FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)
w/o Climate Control Seat System:
Cut off the tack pins and remove the front seatback heater assembly LH from the front separate type seatback cover.
w/ Climate Control Seat System:
Cut off the tack pins and remove the front seatback heater assembly LH from the front separate type seatback cover.
23.REMOVE FRONT SEATBACK PROTECTOR
Remove the front seatback protector.
Remove any remaining double-sided tape.
| *1 | Double-sided Tape |
79121
24.REMOVE NO. 1 SEAT CUSHION BRACKET
86295E
25.REMOVE NO. 2 TELEVISION BASE (w/ Rear Entertainment System)
Detach the 9 clips.
Remove the 4 screws.
Detach the 2 guides and remove the No. 2 television base.
71876G
26.REMOVE OUTSIDE RECLINING ADJUSTER COVER LH
Remove the screw.
Detach the claw and remove the outside reclining adjuster cover LH.
71875F
27.REMOVE OUTSIDE RECLINING ADJUSTER COVER RH
Remove the screw.
Detach the claw and remove the outside reclining adjuster cover RH.
71876
28.REMOVE INSIDE RECLINING ADJUSTER COVER LH
Detach the wire harness clamp.
Remove the 2 screws.
Detach the claw and remove the inside reclining adjuster cover LH.
71875A
29.REMOVE INSIDE RECLINING ADJUSTER COVER RH
Detach the wire harness clamp.
Remove the 2 screws.
Detach the claw and remove the inside reclining adjuster cover RH.
72760D
30.REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH (for Driver Side)
Remove the cable clamp and disconnect the active headrest cable from the seatback spring.
| *1 | Cable Clamp |
| *2 | Hook |
Remove the 4 springs.
Detach the 4 hooks and remove the seatback spring.
Disconnect the connector.
Remove the 2 screws and lumbar support adjuster assembly LH.
31.REMOVE BUSH (for Driver Side)
Detach the 3 claws and remove the bush.
71644
32.REMOVE LOWER ACTIVE HEADREST UNIT
Remove the nut and detach clamp, and then disconnect the active headrest cable from the upper active headrest unit.
Remove the 2 nuts and lower active headrest unit.
71643A
33.REMOVE UPPER ACTIVE HEADREST UNIT
Remove the 4 nuts and upper active headrest unit.
71874
34.REMOVE FRONT LOWER SEAT CUSHION SHIELD LH
Remove the screw.
Detach the hook and remove the lower seat cushion shield LH.
71873
35.REMOVE FRONT LOWER SEAT CUSHION SHIELD RH
Remove the screw.
Detach the hook and remove the lower seat cushion shield RH.
87501D
36.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY (w/ Seat Heater System)
Disconnect the connector and detach the wire harness clamp.
Detach the claw and remove the seat heater control sub-assembly.
85861
37.REMOVE SEAT CLIMATE CONTROL ECU (w/ Climate Control Seat System)
Disconnect the connector.
Detach the claw and remove the seat climate control ECU.
85865A
38.REMOVE SEAT CLIMATE CONTROL CONTROLLER LH (w/ Climate Control Seat System, for Seat Cushion)
Detach the 4 claws and disconnect the seat climate control blower LH.
Detach the wire harness clamp.
Remove the 2 screws and seat climate control controller LH.
85863
39.REMOVE SEAT CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)
Disconnect the connector and remove the 2 bolts.
Detach the wire harness clamp.
Remove the nut and seat climate control blower LH.
88921D
40.REMOVE NO. 1 AIR FILTER (w/ Climate Control Seat System)
Rotate the No. 1 air filter counterclockwise to detach the claws and remove it.
72403
41.REMOVE SEAT FRAME SET BRACKET SUB-ASSEMBLY (w/ Climate Control Seat System)
Detach the 4 hooks and remove the seat frame set bracket sub-assembly.
89178A
42.REMOVE SEAT POSITION SENSOR (for Driver Side)
73920A
43.REMOVE FRONT SEAT AIRBAG ASSEMBLY LH
82192
44.REMOVE FRONT SEAT WIRE LH
Disconnect the connectors and detach the wire harness clamps.
Detach the claw and remove the front seat wire LH.
82666M
45.REMOVE CONNECTOR HOLDER (w/ Rear Entertainment System)
Detach the claw and remove the connector holder.
85822
46.REMOVE POWER SEAT SLIDE MOTOR ASSEMBLY LH
Apply battery voltage to the power seat slide motor assembly LH connector and set the slide position to frontmost.
|
Bolt A |
|
Nut |
|
Bolt B |
Remove the 2 bolts A, 2 bolts B, 2 nuts and power seat slide motor assembly LH.
Do not reuse the removed bolt A and nut.