Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2660E _58 Vehicle Interior _052846 SEAT BELT _0255653 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).



PROCEDURE

Hide 73200A 1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B184509

a.

Align the adjuster positioning hole with the claw, and install the adjuster with the 2 bolts.

HINT:

First install the lower bolt, and then install the upper bolt.


Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73220 2.INSTALL FRONT SEAT OUTER BELT ASSEMBLY

B180625E01
1.646,1.458 1.104,1.031 1.104,1.031 0.51,1.031 true 1.302,1.417 0.927,1.031 true 0.344,0.938 0.5,1.125 0.156,0.188 10 false a

NOTICE:

When installing the retractor, make sure the claws of the vehicle (labeled "a" in the illustration) only contact the installation areas of the retractor.


a.

Align the claws of the vehicle with the seat belt retractor positioning holes.


b.

Install the seat belt with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)


c.
B180626E01
1,0.688 1.208,0.875 0.208,0.188 10 false A 2.802,1.146 3,1.396 0.198,0.25 10 true B 1.479,1 1.677,1.271 0.198,0.271 10 true C

Connect the pretensioner connector labeled A as shown in the illustration.


d.

Connect the tension reducer connector labeled B.


e.

w/ Pre-Crash Safety System:

Connect the pre-crash safety connector labeled C.


f.
B180622

Install the shoulder anchor to the shoulder belt anchor adjuster with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 62414A 5.INSTALL CENTER LOWER PILLAR GARNISH

HINT:
·

for Manual Seat:

When installing the center lower pillar garnish, move the front seat and seatback to the foremost upright position.

·

for Power Seat:

When installing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position.

After moving the front seat, disconnect the cable from the negative (-) battery terminal.



B181678

a.

Attach the 2 claws and 7 clips to install the center lower pillar garnish.


b.
B181677

Install the seat belt anchor with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).