Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2660E _58 Vehicle Interior _052846 SEAT BELT _0255653 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 62414A 7.REMOVE CENTER LOWER PILLAR GARNISH

HINT:
·

for Manual Seat:

When removing the center pillar garnish cover, move the front seat and seatback to the foremost upright position.

·

for Power Seat:

When removing the center pillar garnish cover, connect the cable to the negative (-) battery terminal and operate the power seat switch to move the front seat and seatback to the foremost upright position. After moving the front seat, disconnect the cable from the negative (-) battery terminal.



B181677

a.

Remove the bolt and seat belt anchor.


b.
B181678

Detach the 2 claws and 7 clips, and remove the center lower pillar garnish.


Hide 73220 10.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

B180622

a.

Remove the nut and shoulder anchor.


b.
B180623E01
1.615,1.667 1.74,1.948 0.125,0.281 10 true A 2.573,0.781 2.708,1.125 0.135,0.344 10 true B 1.729,0.698 1.854,1.01 0.125,0.313 10 true C

Disconnect the pretensioner connector labeled A as shown in the illustration.


c.

Disconnect the tension reducer connector labeled B.


d.

w/ Pre-Crash Safety System:

Disconnect the pre-crash safety connector labeled C.


e.
B180624

Remove the bolt and seat belt.


Hide 73200A 11.REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

B184509

a.

Remove the 2 bolts and adjuster.