Home › Vehicle Interior › SEAT BELT › REAR NO. 1 SEAT OUTER BELT ASSEMBLY
RM2660E _58 Vehicle Interior _052846 SEAT BELT _0255657 REAR NO. 1 SEAT OUTER BELT ASSEMBLY A

SEAT BELT  REAR NO. 1 SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 64910J 3.REMOVE TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)

Hide 4.REMOVE REAR NO. 2 SEAT ASSEMBLY (w/ Rear No. 2 Seat)

Hide 64937A 8.REMOVE NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

Hide 71866B 9.REMOVE REAR NO. 2 SEAT COVER BEZEL (w/ Rear No. 2 Seat)

Hide 62520P 10.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH

B182644

HINT:

When removing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.


B181687

a.

Detach the 3 claws and remove the cover.


b.
B181689

Remove the bolt and disconnect the rear seat outer belt floor anchor.


c.
B181691

w/ Rear No. 2 Seat, for LH side:

i.

Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor LH.



d.
B181692

w/ Rear No. 2 Seat, for RH side:

i.

Detach the 3 claws and remove the cover.


ii.
B181693

Remove the bolt and disconnect the rear No. 2 seat outer belt floor anchor RH.



e.

w/o Tonneau Cover:

i.

Remove the clip and bolt.


ii.

Detach the 18 clips and 2 claws.


iii.

w/o Rear Air Conditioning System:

Disconnect the rear seat lock control lever cable and then remove the quarter trim panel.


iv.

w/ Rear Air Conditioning System:

Disconnect the thermistor connector and rear seat lock control lever cable, and then remove the quarter trim panel.

B186889



f.

w/ Tonneau Cover:

i.

Remove the screw and clip.


ii.

Detach the 18 clips and 2 claws, and remove the quarter trim panel.

B186437



Hide 73370C 12.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH

B184510

a.

Remove the nut and seat belt shoulder anchor.


b.
B180641

w/ Pretensioner:

Disconnect the pretensioner connector as shown in the illustration.


c.
B443902

Remove the 2 bolts and rear No. 1 seat outer belt.


Hide 73034 13.REMOVE REAR SHOULDER BELT ANCHOR PLATE SUB-ASSEMBLY LH

B184521

a.

Remove the 2 bolts and anchor plate.