Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73101A
1.INSTALL FRONT SEAT OUTER LAP BELT SUB-ASSEMBLY
Install the front seat outer lap belt sub-assembly with the bolt.
| *a | Front |
73200A
2.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
Align the adjuster positioning hole with the claw, and install the front shoulder belt anchor adjuster assembly with the 2 bolts.
First install the lower bolt, and then install the upper bolt.
73220
3.INSTALL FRONT SEAT OUTER BELT ASSEMBLY LH
Align the 2 claws of the vehicle with the seat belt retractor positioning holes.
Install the front seat outer belt assembly LH with the bolt.
Install the shoulder anchor to the front shoulder belt anchor adjuster assembly with the nut.
62412
4.INSTALL CENTER PILLAR GARNISH LH
74620A
5.INSTALL REAR ASSIST GRIP ASSEMBLY
62414A
6.INSTALL CENTER LOWER PILLAR GARNISH LH
When installing the center lower pillar garnish, move the front seat and seatback to the foremost upright position.
After moving the front seat, disconnect the cable from the negative (-) battery terminal.
Attach the 3 claws and 6 clips to install the center lower pillar garnish.
Install the seat belt anchor with the bolt.
62422
7.INSTALL CENTER PILLAR GARNISH COVER LH
67918E
8.INSTALL REAR DOOR SCUFF PLATE LH
51775
9.INSTALL REAR STEP COVER
67914B
10.INSTALL FRONT DOOR SCUFF PLATE LH
11.INSTALL FRONT SEAT ASSEMBLY RH