The ambient temperature sensor is installed in the front part of the condenser to detect the ambient temperature and control the air conditioner "auto" mode. The sensor connected to the air conditioning amplifier assembly detects fluctuations in the ambient temperature. This data is used for controlling the room temperature. The sensor sends a signal to the air conditioning amplifier assembly. The resistance of the ambient temperature sensor changes in accordance with the ambient temperature. As the temperature decreases, the resistance increases. As the temperature increases, the resistance decreases.
The air conditioning amplifier assembly applies voltage (5 V) to the ambient temperature sensor and reads voltage changes as the resistance of the ambient temperature sensor changes.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1412/12 | An open or short in the ambient temperature sensor circuit. | ·
Cooler thermistor (ambient temperature sensor) ·
Harness or connector ·
Air conditioning amplifier assembly |
w/ Rear Heater:
w/o Rear Heater:
Use the Data List to check if the cooler thermistor (ambient temperature sensor) is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Ambient Temp Sensor | Ambient temperature sensor / Min: -23.3°C (-9.94°F), Max: 65.95°C (150.71°F) | Actual ambient temperature displayed | Thermistor assembly (ambient temperature sensor) system malfunction:
·
Open in the circuit: -23.3°C (-9.94°F) ·
Short in the circuit: 65.95°C (150.71°F) |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to the DTC) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
A
B
C
Remove the cooler thermistor (ambient temperature sensor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AMBIENT TEMPERATURE SENSOR>REMOVAL).
Inspect the cooler thermistor (ambient temperature sensor) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AMBIENT TEMPERATURE SENSOR>INSPECTION).
OK
NG
*1: w/o Door Ajar Warning Buzzer
*2: w/ Door Ajar Warning Buzzer
w/ Rear Heater:
Disconnect the A14*1 or A85*2 cooler thermistor (ambient temperature sensor) connector.
Disconnect the E35 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A14-1 - E35-10 (TAM) | Always | Below 1 Ω |
| A14-2 - E35-32 (SG-2) | Always | Below 1 Ω |
| A14-1 - A14-2 | Always | 10 kΩ or higher |
| A14-1 or E35-10 (TAM) - Body ground | Always | 10 kΩ or higher |
| A14-2 or E35-32 (SG-2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A85-1 - E35-10 (TAM) | Always | Below 1 Ω |
| A85-2 - E35-32 (SG-2) | Always | Below 1 Ω |
| A85-1 - A85-2 | Always | 10 kΩ or higher |
| A85-1 or E35-10 (TAM) - Body ground | Always | 10 kΩ or higher |
| A85-2 or E35-32 (SG-2) - Body ground | Always | 10 kΩ or higher |
w/o Rear Heater:
Disconnect the A14*1 or A85*2 cooler thermistor (ambient temperature sensor) connector.
Disconnect the E81 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A14-1 - E81-5 (TAM) | Always | Below 1 Ω |
| A14-2 - E81-13 (SG-2) | Always | Below 1 Ω |
| A14-1 - A14-2 | Always | 10 kΩ or higher |
| A14-1 or E81-5 (TAM) - Body ground | Always | 10 kΩ or higher |
| A14-2 or E81-13 (SG-2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A85-1 - E81-5 (TAM) | Always | Below 1 Ω |
| A85-2 - E81-13 (SG-2) | Always | Below 1 Ω |
| A85-1 - A85-2 | Always | 10 kΩ or higher |
| A85-1 or E81-5 (TAM) - Body ground | Always | 10 kΩ or higher |
| A85-2 or E81-13 (SG-2) - Body ground | Always | 10 kΩ or higher |
OK
NG