The main power source is supplied to the air conditioning amplifier assembly when the engine switch is on (IG). The power source is used for operating the air conditioning amplifier assembly and servo motor, etc.
Start the engine before inspection. Check the relay or battery if the entry and start system does not start.
Remove the ECU-IG NO. 2 fuse from the cowl side junction block LH.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| ECU-IG NO. 2 fuse | Always | Below 1 Ω |
OK
NG
w/ Rear Heater
Disconnect the E35 and E36 amplifier connectors.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E36-5 (IG+) - Body ground | Engine switch off | Below 1 V |
| Engine switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E36-1 (GND) - Body ground | Always | Below 1 Ω |
| E36-2 (E1) - Body ground | ||
| E35-6 (E2) - Body ground |
w/o Rear Heater
Disconnect the E81 amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| E81-1 (IG+) - Body ground | Engine switch off | Below 1 V |
| Engine switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E81-14 (GND) - Body ground | Always | Below 1 Ω |
OK
NG