Use the same procedures for the LHD vehicle and RHD vehicle.
The procedures listed below are for the LHD vehicle.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Passenger Side Knee Airbag)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67913B
3.REMOVE FRONT DOOR SCUFF PLATE RH
w/ Sliding Roof:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/ Sliding Roof)>REMOVAL)
w/o Sliding Roof:
(See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING (w/o Sliding Roof)>REMOVAL)
55448A
4.REMOVE NO. 1 INSTRUMENT PANEL FINISH CUSHION
55402C
5.REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
55607
6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Floor Under Cover)
73990
7.REMOVE FRONT PASSENGER SIDE KNEE AIRBAG ASSEMBLY (w/ Passenger Side Knee Airbag)
55312
8.REMOVE LOWER INSTRUMENT PANEL (w/o Passenger Side Knee Airbag)
55476A
9.REMOVE NO. 3 INSTRUMENT CLUSTER FINISH PANEL GARNISH
55433B
10.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL
88650N
11.REMOVE AIR CONDITIONER AMPLIFIER ASSEMBLY
Disconnect the connector.
Remove the screw and amplifier.