Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) › 2014.08–2015.08
RM2660E _58 Vehicle Interior _052847 HEATING / AIR CONDITIONING _0255699 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when turning the engine switch off and is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E160327E04
0.188,0.604 0.979,0.792 0.792,0.188 10 false from Battery 5.479,0.427 5.76,0.604 0.281,0.177 10 false 6*1 5.063,0.427 5.5,0.604 0.438,0.177 10 false 21*2 0.49,2.844 1.865,3.021 1.375,0.177 10 false 1*: w/ Rear Heater 0.5,3.188 1.875,3.365 1.375,0.177 10 false 2*: w/o Rear Heater 5.438,0.625 5.75,0.781 0.313,0.156 10 false E36 5.448,1.24 5.76,1.406 0.313,0.167 10 false E36 5.083,0.615 5.396,0.771 0.313,0.156 10 false E81 5.354,3.052 6.969,3.438 1.615,0.385 10 false Air Conditioning Amplifier Assembly 2.542,0.771 2.885,0.969 0.344,0.198 10 false A/C 5.823,0.615 6.125,0.813 0.302,0.198 10 false +B1 5.479,1.052 5.75,1.229 0.271,0.177 10 false 7*1 5.813,1.24 6.115,1.438 0.302,0.198 10 false +B2

PROCEDURE

1.INSPECT FUSE (A/C)
a.

Remove the A/C fuse from the cowl side junction block LH.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A/C fuse Always Below 1 Ω




OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)

NG

REPLACE FUSE

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY)
U165942E01
0.091,0.083 2.689,0.429 2.599,0.346 10 Rear view of wire harness connector: (to Air Conditioning Amplifier Assembly) 1.532,1.346 1.823,1.522 0.291,0.175 10 E36 1.184,3.051 0.859,3.197 false 1.339,3.052 1.13,3.965 false 0.906,3.987 1.210,4.158 0.304,0.171 10 +B1 0.511,3.116 0.815,3.287 0.304,0.171 10 +B2

a.

w/ Rear Heater

i.

Disconnect the E36 amplifier connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E36-6 (+B1) - Body ground Always 11 to 14 V
E36-7 (+B2) - Body ground




b.
U166043E01
0.128,0.092 2.618,0.507 2.489,0.415 10 Rear view of wire harness connector: (to Air Conditioning Amplifier Assembly) 1.591,1.11 1.863,1.272 0.272,0.163 10 E81 2.161,2.995 2.472,3.158 0.311,0.163 10 B1+ 2.513,2.517 2.334,2.994 false

w/o Rear Heater

i.

Disconnect the E81amplifier connector.


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E81-21 (+B1) - Body ground Always 11 to 14 V





OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR