PTC heater relays are closed in accordance with signals from the air conditioning amplifier assembly and power is supplied to the quick heater assembly installed on the radiator heater unit.
Remove the PTC HTR1 relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
OK
NG
Remove the PTC HTR2 relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
OK
NG
Remove the PTC HTR3 relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied between terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
OK
NG
w/ Rear Heater
Remove the air conditioning amplifier assembly with its connectors still connected (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E36-27 (PTC1) - Body ground | Engine switch on (IG)
Temperature setting: MAX, HOT MODE switch: FOOT Engine coolant temperature: 55°C (131°F) or less Blower switch: off |
11 to 14 V |
| E36-26 (PTC2) - Body ground | ||
| E36-35 (PTC3) - Body ground |
w/o Rear Heater
Remove the air conditioning amplifier assembly with its connectors still connected (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E81-3 (PTC1) - Body ground | Engine switch on (IG)
Temperature setting: MAX, HOT MODE switch: FOOT Engine coolant temperature: 55°C (131°F) or less Blower switch: off |
11 to 14 V |
| E81-22 (PTC2) - Body ground | ||
| E81-4 (PTC3) - Body ground |
OK
NG
Remove the quick heater relays from the engine room relay block.
Disconnect the E33 quick heater assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| PTC HTR2 terminal 3 - E33-1 (B) | Always | Below 1 Ω |
| PTC HTR1 terminal 3 - E33-2 (B) | ||
| PTC HTR3 terminal 3 - E33-3 (B) | ||
| PTC HTR2 terminal 3 - Body ground | Always | 10 kΩ or higher |
| PTC HTR1 terminal 3 - Body ground | ||
| PTC HTR3 terminal 3 - Body ground |
OK
NG
Disconnect the E33 and E34 quick heater connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E33-1 (B) - E34-1 (E) | Always | Below 1 Ω |
| E33-2 (B) - E34-1 (E) | ||
| E33-3 (B) - E34-2 (E) |
OK
NG
Disconnect the E34 quick heater assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E34-1 (E) - Body ground | Always | 10 kΩ or higher |
| E34-2 (E) - Body ground |
OK
NG
w/ Rear Heater
Disconnect the E36 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E36-27 (PTC1) - Body ground | Always | Below 1 Ω |
| E36-26 (PTC2) - Body ground | ||
| E36-35 (PTC3) - Body ground |
w/o Rear Heater
Disconnect the E81 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E81-3 (PTC1) - Body ground | Always | Below 1 Ω |
| E81-22 (PTC2) - Body ground | ||
| E81-4 (PTC3) - Body ground |
| Result | Proceed to |
|---|---|
| OK (for LHD) | A |
| OK (for RHD) | B |
| NG | C |
OK
NG