*1: for LHD
*2: for RHD
The mode damper servo motor RH*1 or LH*2 sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the mode damper servo motor RH*1 or LH*2 to any position, which controls the air outlet changes.
Confirm that no mechanical problem is present because this trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1448/48 | The air outlet damper position does not change even if the air conditioning amplifier assembly operates the air outlet damper servo motor. | ·
Mode damper servo motor RH*1 ·
Mode damper servo motor LH*2 ·
Air conditioning harness assembly ·
Air conditioning amplifier assembly |
w/ Rear Heater:
w/o Rear Heater:
*1: for LHD
*2: for RHD
Use the Data List to check if the mode damper servo motor RH*1 or LH*2 is functioning properly (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Outlet Servo Targ Pulse(P) | Mode damper servo motor RH*1 or LH*2 target pulse / Min.: 128, Max.: 383 | for LHD:
·
FACE: 254 (pulse) ·
FACE1: 246 (pulse) ·
FACE2: 254 (pulse) ·
B/L1: 230 (pulse) ·
B/L2: 218 (pulse) ·
FOOT-O: 208 (pulse) ·
FOOT-D: 189 (pulse) ·
FOOT-R: 178 (pulse) ·
FOOT-F: 178 (pulse) ·
FOOT 178 (pulse) ·
F/D: 155 (pulse) ·
DEF: 143 (pulse) for RHD:
·
FACE: 258 (pulse) ·
FACE1: 266 (pulse) ·
FACE2: 258 (pulse) ·
B/L1: 282 (pulse) ·
B/L2: 294 (pulse) ·
FOOT-O: 304 (pulse) ·
FOOT-D: 323 (pulse) ·
FOOT-R: 334 (pulse) ·
FOOT-F: 334 (pulse) ·
FOOT 334 (pulse) ·
F/D: 357 (pulse) ·
DEF: 369 (pulse) |
·
Displayed between 143 and 254 pulse (for LHD) ·
Displayed between 258 and 369 pulse (for RHD) ·
Mode damper servo motor RH*1 or LH*2 system malfunction |
| Air Outlet Servo Actu Pulse(P) | Mode damper servo motor RH*1 or LH*2 actual pulse / Min.: 128, Max.: 383 | for LHD:
·
FACE: 254 (pulse) ·
FACE1: 246 (pulse) ·
FACE2: 254 (pulse) ·
B/L1: 230 (pulse) ·
B/L2: 218 (pulse) ·
FOOT-O: 208 (pulse) ·
FOOT-D: 189 (pulse) ·
FOOT-R: 178 (pulse) ·
FOOT-F: 178 (pulse) ·
FOOT 178 (pulse) ·
F/D: 155 (pulse) ·
DEF: 143 (pulse) for RHD:
·
FACE: 258 (pulse) ·
FACE1: 266 (pulse) ·
FACE2: 258 (pulse) ·
B/L1: 282 (pulse) ·
B/L2: 294 (pulse) ·
FOOT-O: 304 (pulse) ·
FOOT-D: 323 (pulse) ·
FOOT-R: 334 (pulse) ·
FOOT-F: 334 (pulse) ·
FOOT 334 (pulse) ·
F/D: 357 (pulse) ·
DEF: 369 (pulse) |
·
Displayed between 143 and 254 pulse (for LHD) ·
Displayed between 258 and 369 pulse (for RHD) ·
Mode damper servo motor RH*1 or LH*2 system malfunction |
When the front passenger side mode switch is turned, the actual pulse changes following the target pulse.
| Result | Proceed to |
|---|---|
| Target pulse changes but actual pulse does not change | A |
| Target pulse and actual pulse do not change | B |
| Actual pulse changes following the target pulse (When troubleshooting according to the DTC) | C |
| Actual pulse changes following the target pulse (When troubleshooting according to Problem Symptoms Table) | D |
A
B
C
E
for LHD:
Replace the mode damper servo motor RH (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT (for LHD)>DISASSEMBLY).
for RHD:
Replace the mode damper servo motor LH (See pageVehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT (for RHD)>DISASSEMBLY ).
Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a normal one.
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1448/482 is not output.
OK
NG
Replace the air conditioning harness assembly with a new or known one.
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1448/482 is not output.
OK
NG
Check for DTCs (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)>DTC CHECK / CLEAR).
DTC B1448/482 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG